Overall Trends
Total, fatal, and serious accidents in the selected range.
Search investigations, review source evidence, monitor watched reports, and trace long-term patterns from one calm, data-first workspace.
Fast key and full-text search with live filters, watches, and precise metadata.
Use quotes for exact phrase matches (for example "fuel selector valve").
Track fatal and non-fatal accident patterns across Part 91, Part 135, and Part 121 operations.
Major cases, deep-report coverage, and investigation media across decades of NTSB history.
Move quickly by aircraft, airport, operator, and time with indexes built for research, not wandering.
NTSB Reports is an independent research and search tool for public aviation accident and incident records. It brings NTSB aviation reports, structured fields, docket files, extracted figures, photos, videos, and update history into one searchable interface.
The goal is practical safety education: make it faster to find relevant investigations, compare similar events, review factual records, and understand the evidence behind probable-cause and preliminary reports.
The investigative work and source records belong to the National Transportation Safety Board and the published investigation record. This site is not affiliated with or endorsed by the NTSB.
Coldfoot, AK
The airplane had just received a 100-hour inspection from a contract maintenance facility. The pilot was landing the tundra tire, tailwheel-equipped airplane on a gravel runway. During the flight, the pilot utilized a short section of tubing to direct heater air at his feet. During the landing touchdown, the pilot discovered the brakes were locked. The tires skidded on the gravel surface of the runway and the left wing struck the ground. The pilot indicated the brakes remained locked for about 2 hours after the accident. At that time, the wheels turned normally. The airplane utilizes a separate master brake cylinder/brake pedal assembly for each main wheel brake. The master cylinder/brake pedals are located on the cockpit floor, adjacent to the rudder pedals. The brake cylinders are normally serviced by adding hydraulic brake fluid through a small cap on the top of each cylinder. Maintenance personnel from the operator reported that overservicing of the brake cylinders, and heating of the cylinder assembly produced a locked brake condition.
The overservicing/pressurizing of the hydraulic brake system by maintenance personnel that locked the brake system and prevented directional control.
On September 18, 1997, about 1330 Alaska daylight time, a tundra tire equipped Piper PA-18, N2355H, crashed during landing at the Coldfoot Airport, Coldfoot, Alaska. The airplane was being operated as a visual flight rules (VFR) cross-country government flight under Title 14 CFR Part 91 when the accident occurred. The airplane, operated by the State of Alaska, Department of Public Safety, Division of Fish and Wildlife Protection, sustained substantial damage. The certificated private pilot, the sole occupant, was not injured. Visual meteorological conditions prevailed. VFR flight following procedures were in effect. The flight originated at the Fairbanks International Airport, Fairbanks, Alaska, about 1030. The operator reported the airplane had just received a 100 hour inspection from a contract maintenance facility in Fairbanks, Alaska, and the pilot was returning to his post in Coldfoot. During the flight, the pilot utilized a short section of tubing to direct heater air to his feet. The pilot landed on runway 19 at Coldfoot. When the airplane touched down, the pilot discovered the brakes were locked. The tires skidded on the gravel surface of the runway, and the left wing struck the ground. The pilot indicated the brakes remained locked for about 2 hours after the accident. At that time, the wheels turned normally. The airplane manufacturer reported the airplane utilizes a separate master brake cylinder/brake pedal assembly for each main wheel brake. The master cylinder/brake pedals are located on the cockpit floor, adjacent to the rudder pedals. The brake cylinders are normally serviced by adding hydraulic brake fluid through a small cap on the top of each cylinder. Maintenance personnel from the operator reported that over-servicing of the brake cylinders, and heating of the cylinder assembly produced a locked brake condition.