On September 2, 1993, at 1203 central daylight time, a McDonnell-Douglas DC-9-82, N918TW, operated by Trans World Airlines, Incorporated, as Flight 359, experienced a total hydraulic failure while taxiing to the parking gate after landing. The 14 CFR Part 121 flight had been operating on an IFR flight plan. Visual meteorological conditions prevailed at the time of the incident. The pilot, three flight attendants, and 103 passengers were not injured. The flight originated from New York, New York, at 1026 eastern daylight time. The captain on Flight 359 stated: "At approximately 700 AFE I completed the landing check list and noted that there were no warning lights illuminated on the annunciator panel. Touchdown and initial roll-out were normal and F/O Harski initiated proper reverse and braking techniques slowing the aircraft to approximately 65 knots." The captain said he took control of the aircraft at this time and continued braking the aircraft. When the airplane was slowed to four to five knots, the captain said he attempted to turn the airplane's nose wheel to exit the runway. "...I attempted to turn the nose wheel steering wheel to exit the runway but found that it was extremely difficult to turn." He stated he was able to turn the aircraft to a 45 degree angle to the runway heading. The captain said he "...found out that not only could I not turn the aircraft any further to the left but also I could not straighten out the nosewheel." The pilot stated he applied brakes and found them not available. He said, "I applied full left rudder in hope this would further turn the airplane so that I could position the airplane..." on the taxiway. The airplane turned back onto the taxiway and the pilot attempted to use reverse thrust to stop it. Reverse thrust did not stop the airplane and it rolled off the edge, coming to a stop in the grass area adjacent to the taxiway. According to the captain, he and the first officer confirmed "...that the hydraulic gauges indicated that both left and right reservoirs had sufficient fluid in them to provide hydraulic pressure. We also confirmed that all four hydraulic pumps were on." The on-scene investigation revealed the power transfer unit (PTU) made the hydraulic system pressure go to zero when it was opened while operating on the left or right hydraulic system. Closing the PTU returned the hydraulic system to normal. Examination of the PTU housing revealed it was cracked around its entire circumference. Hydraulic fluid had not leaked from the crack in the unit. A November 9, 1992, Allied-Signal Aerospace Company service bulletin that applied to N918TW recommended the PTU's cast aluminum housings be replaced with a wrought iron housing due to previous unit housing cracking history. N918TW's PTU was the cast aluminum type. A McDonnell-Douglas service bulletin addressed procedures to handle low hydraulic pressure with the system annunciator lights illuminated. According to the flight crew, the system annunciator lights were not illuminated. The company's maintenance personnel performed an operational check of the annunciator panel. The check showed the system annunciator lights were functional. The NTSB's Materials Laboratory Division examined the PTU housing. The report states: "Visual examination of the housing fracture surface indicated that the fracture was brittle and had no evidence of plastic deformation." The housing's fatigue fracture covered approximately 270 degrees of the circumference. The remaining portion of the fracture was typical of overstress separation. Examination revealed that in some areas the fatigue features stemmed from large shrinkage cavities. The metallurgists report states: "However, the vast majority of the fatigue crack origins were associated with large inclusions, which were identified as silicon inclusions... ." The Allied Signal and McDonnell-Douglas service bulletins are appended to this report. The NTSB's Materials Laboratory Division metallurgist's report is appended to this report.