On November 18, 2003, about 1452 Pacific standard time, a Bell/Soloy 47G-3B-2 helicopter, N7825S, which was converted to accommodate a Rolls Royce 250-C20 series turbine engine, sustained substantial damage during a forced landing following an in-flight loss of a tail rotor blade, about 6 miles south of Monmouth, Oregon. The helicopter was being operated under the provisions of Title 14, CFR Part 133, conducting external load operations (utilizing a 50 foot long-line) in support of a Christmas tree harvest when the accident occurred. The helicopter is registered to, and operated by, Farm and Forest Helicopter Service of Napavine, Washington. The certificated commercial pilot, the solo occupant, received serious injuries. Following the accident the pilot told local law enforcement personnel that while in a stable hover, about 40-50 feet above ground level (AGL), he lost tail rotor control authority, and was unable to maintain directional control. A witness to the accident reported that he observed a section of tail rotor blade depart the helicopter during the hover operation just before the accident sequence. He reported the helicopter subsequently entered a series of 360-degree rotations just before impacting terrain in a nose low attitude. In a written statement dated November 24, 2003, the pilot reported he was hovering, into the wind, over the "drop off point" when he heard a loud noise emanating from the rear of the helicopter. He described that the helicopter "instantly" began to rotate around its vertical axis and shortly after jettisoning the load the helicopter impacted terrain. An FAA representative from the Portland, Oregon, Flight Standards District Office conducted the post accident onsite examination of the wreckage. The inspector reported the helicopter sustained substantial damage consistent with a hard landing. Both main rotor blades struck the ground, but remained attached. One of the blades struck and bent the pylon. The skids were spread and broken. The engine and transmission were displaced from their mounts. The cockpit bubble was broken and the pilot's seat was buckled upward and forward. During the examination it was noted that the tail rotor blades and tail rotor gearbox were separated from the helicopter's tail assembly. The tail rotor gearbox and one of the tail rotor blades was later located in a ditch near the accident site. The second tail rotor blade was located underneath a conifer tree approximately 100 feet east of the wreckage. Following the onsite examination, the tail rotor hub, 90-degree gearbox and blade assembly was shipped to Bell Helicopter, Fort Worth, Texas, for further examination and testing. Examination of the fractured tail rotor blade (S/N A-2522) by personnel from Bell Helicopter and NTSB revealed that the blade fractured as a result of fatigue. According to the engineering laboratory report submitted by Bell Helicopter, the fatigue had multiple origins on the inside surface of the skin near the outboard end of the butt block (approximately 7.6 inches from the inboard end and 1.38-1.6 inches from the leading edge). Several of the origins were in pitted areas measuring no deeper than .00033 inches. The pits are the result of an etching process used to prepare the surface for bonding. The report concludes that the surface condition was "typical of properly prepared surface and no abnormalities were found." Examination of the opposing blade (S/N A-2500) revealed fatigue cracking on the bottom skin in a similar location as blade A-2522. The origins of the cracks were in areas of pitting attributed to the etching process. The pits measured no deeper than .00017 inches and according to the manufacture were consistent with a properly prepared surface with no anomalies. The 90-degree gearbox was evaluated during the tail rotor assembly examination. According to the engineering report, wear patterns on the spiral bevel gear was consistent with heavy loading. Logbook records indicated that the tail rotor blades had accumulated approximately 1,723 hours since new. The life limit for the tail rotor blades is 2,500 hours. Bell Helicopters manufactured the tail rotor blades on January 26, 1999.