On June 1, 2009, about 1500 eastern daylight time, a Cirrus Design Corp. SR22, N695CD, registered to and operated by SATSair LLC. as a Title 14 Code of Federal regulations Part 91 maintenance flight, experienced a control malfunction while on approach to Greenville Downtown Airport (GMU), Greenville, South Carolina. The certificated airline transport pilot was not injured and the airplane was not damaged. Visual meteorological conditions prevailed and no flight planned was filed. The flight departed from GMU at 1430. The pilot reported that he was "returning the airplane to service," following a maintenance inspection. No anomalies were noted during the preflight inspection, engine start, taxi, run-up, and takeoff roll. As the airplane became airborne, the pilot noticed that the elevator control felt "loose," with about 1/2 inch of "play." The pilot proceeded to an area west of GMU, where he performed in-fight checks uneventfully. As the airplane was returning to GMU, on short final approach, the pilot reduced the throttle to idle power for landing. Subsequently, about 25 feet above ground level, the nose pitched down. The pilot tried to pull back on the yoke to flare, but the elevator control was stuck in the mid-range position. The airplane touched down on the nose gear first and then bounced back up into the air. The sudden jolt of the touchdown seemed to free the elevator control and the pilot was able complete a normal landing. As the pilot taxied from the runway, he was able to duplicate the control jam. The operator's director of maintenance (DOM) reported that no work was performed on the pitch trim cartridge during the recent maintenance inspection. After the incident, the elevator pitch trim cartridge was removed. When the DOM actuated the cartridge by hand, he felt the spring functioning, but noted that the control rod movement was "gritty." The DOM further stated that the anomaly did not reoccur after the pitch trim cartridge was removed and replaced. The airplane's pitch trim cartridge was forwarded to the manufacturer's facility for further examination under the supervision of a Federal Aviation Administration (FAA) inspector. The examination revealed some corrosion and black grease residue was present; however, there was no conclusive evidence found to support a flight control jam. Additionally, the manufacturer's representatives were not able to document the suspect cartridge as it was installed, before it was removed and replaced. A manufacturer's representative added that although the elevator control linkage moves through the pitch trim cartridge to the aft elevator bellcrank, an electric elevator trim motor moves the entire pitch trim cartridge and aft elevator bellcrank, which provides system redundancy in the event of a primary elevator control malfunction. The DOM subsequently reported that the suspect pitch trim cartridge had been the original cartridge installed on the airplane and that the airplane had been operated for 2,562 hours at the time of the event. Although the pitch trim cartridge was required to be inspected, there was no requirement to replace it at a specific time interval. After the incident, the operator implemented a program to voluntarily remove and replace pitch trim cartridges at 2,000 hours of operation, and forward the used cartridges to the manufacturer for examination. During the investigation, another operator reported similar issues pertaining to trim cartridge "sticking," involving five Cirrus airplanes. Those events occurred shortly after the new airplanes left the factory. Subsequent interviews with mechanics and an FAA inspector, along with further information from the second operator, revealed that one airplane had an elevator pitch trim cartridge sticking due to a lack of lubrication. Another airplane had a roll trim cartridge removed and replaced at the customer's request, in an effort to troubleshoot a wing-rocking problem. The other three airplanes were noted to have trim cartridge (roll, yaw, and/or pitch) sticking possibly due to an aileron-rudder interconnect issue, cartridge misalignment, and/or debris particles becoming temporarily stuck in the cartridge. Review of the National Transportation Safety Board database and FAA service difficulty reports, for a 5-year period preceding the SATSair incident, did not reveal any similar occurrences pertaining to sticking or temporary jamming of any Cirrus pitch trim cartridge.