On November 3, 2012, about 1040 central daylight time, a Cessna 172S, N985GE, impacted an automobile on final approach to runway 17 (3,500 feet by 40 feet, asphalt) at the Northwest Regional Airport (52F), Roanoke, Texas. The student pilot was not injured. The automobile driver and passenger sustained minor injuries. The airplane was substantially damaged. The aircraft was registered to and operated by Marcair, Inc. under the provisions of 14 Code of Federal Regulations Part 91 as a solo instructional flight. Visual meteorological conditions prevailed for the flight, which was operated on a visual flight rules flight plan. The cross-country flight originated from Possum Kingdom Airport (F35), Graford, Texas, about 1005, with an intended destination of 52F. The student pilot reported that he was returning from a solo cross-country flight, entered a left traffic pattern for runway 17 at 52F. He recalled that the approach was normal and the airspeed was about 60 knots when crossing the fence near the end of the runway. He stated that just after crossing the fence the landing gear impacted an automobile, which resulted in a hard landing. The nose and left main landing gear collapsed, and the airplane veered off the right side of the runway before coming to rest in the grass. The student pilot stated that there were no malfunctions or failures associated with the airplane before impacting the automobile. The driver of the automobile reported that he had been to the airport before and was aware of the proximity of the road to the runway, describing the layout as "precarious." He noted that he did not see or hear the approaching airplane traffic prior to the accident; although, he had rolled the car windows down and turned off the radio to assist in hearing any airplane traffic. He stated that the vehicle was about halfway across the road immediately north of the runway when he first heard the airplane engine. The airplane impacted his car immediately afterward. He noted that the airplane impacted his car about 4-1/2 feet above the road. The accident airport consisted of a single north-south oriented runway, designated 17 / 35. The published runway dimensions at the time of the accident were 3,500 feet by 40 feet. Although the Federal Aviation Administration (FAA) Airport Facility Directory (AFD) current at the time of the accident noted a 400-foot displaced threshold for runway 17, the runway threshold was actually displaced approximately 140 feet at the time of the accident. Satellite imagery indicated that the runway threshold markings were changed sometime between June 12, 2011, and the date of the accident. The edge of the roadway crossing the runway 17 approach path was located about 25 feet from the end of the runway; about 165 feet from the displaced threshold. The roadway was marked with a faded "Stop" indication painted on the pavement at each side of the runway. However, there were no signs requiring drivers to stop or advising them of low flying aircraft. Because the accident airport was privately owned, the airport management was under no obligation to maintain the airport to any federal standard. Federal Aviation Administration (FAA) airport design guidance (Advisory Circular 150/5300-13A) noted a standard approach slope of 20:1, or about 3 degrees. Guidance related to Visual Approach Slope Indicators (VASI), contained in Chapter 2 of the FAA Aeronautical Information Manual, noted that a standard runway glide path angle is 3 degrees; however, the glide path angle may be up to 4.5 degrees if necessary for obstacle clearance. The calculated glide path height above the roadway, considering a 165-foot distance between the displaced runway threshold and the edge of the roadway, would be 8.6 feet and 13.0 feet for a 3-degree and a 4.5 degree glide path, respectively. This does not take into account any difference in the elevation of the roadway relative to the runway, nor does it include any safety margin for momentary inadvertent operations slightly below the glidepath.