On May 12, 2016, about 1413 Pacific daylight time, a Cessna 208B, N1114A, was substantially damaged during a forced landing near Acampo, California. The airplane was registered to Flanagan Enterprises (Nevada) INC., and operated by the Parachute Center under the provisions of 14 Code of Federal Regulations Part 91. The commercial pilot sustained minor injuries and his 17 passengers were not injured. Visual meteorological conditions prevailed and no flight plan was filed for the skydiving flight. The local flight originated about 1 minute prior to the accident. The pilot reported that following takeoff from runway 26, he made a right turn and continued his climb for the skydive drop, however, as the airplane passed 1,000 ft above ground level (agl), the engine lost power. The pilot initiated a turn toward the airport, however, realized he was unable to make it, and landed in an open field. During the landing roll, the airplane exited the field, crossed a road, impacted a truck, continued into a vineyard, and nosed over. Examination of the airplane by a Federal Aviation Administration inspector revealed that the fuselage and left wing were substantially damaged. The wreckage was recovered to a secure location for further examination. Examination of the recovered wreckage was conducted on May 17 and 18, 2016. The engine remained partially attached to the fuselage. The fuel pressure line that connects the fuel control unit to the airframe fuel pressure transducer, Pratt & Whitney Canada (PWC) part number 3033981, was fractured below the fuel control unit fitting swaged seat. The supporting clamp, PWC part number 3006614, was fractured and was separated from its mating fuel pressure fuel line, PWC part number 3032010. In addition, the airframe P3 air line that provides air to the vacuum system exhibited a hole within the tube. The operator reported that they had replaced the fuel line, PWC part number 3033981, the night before the accident due to the original fuel line being fractured. They stated that the new fuel line had about 4 hours of operational time since the installation. Review of the maintenance logbooks revealed that an entry regarding the replacement of the fuel line was dated April 11, 2016, with no airframe, engine, or HOBBS meter times listed. The operator was further questioned about what manual they used regarding engine maintenance and they replied they used the manufacturers manual for all engine related maintenance. When questioned about the supporting clamp, PWC part number 3006614, the operator stated that the clamp was attached at the time of the fuel line replacement. Both the new and old fuel lines and separated clamp were sent to the National Transportation Safety Board Materials Laboratory for further examination. A Senior Materials Engineer examined the fuel lines and clamp and reported that the fuel line fracture surfaces were examined with the aid of a digital optical microscope and a scanning electron microscope and both fractured tubes were found to exhibit features consistent with crack initiation due to reverse bending fatigue. The metal band of the clamp was fractured near the intersection of the tab and the loop portion of the clamp. The fracture surfaces were examined and exhibited features consistent with crack initiation at the inward-facing side of the tab due to bending fatigue. The fracture surface exhibited a comparatively flat appearance with curved crack progression marks on the fracture surface consistent with the crack initiating on the inward-facing side of the tab. For further information, see the Materials Laboratory Factual Report within the public docket for this accident.